Contrôleur brushless pro 60A BEC

Contrôleur brushless pro 60A BEC V2

Plus de détails



AddThis Social Bookmark Button

60-Amp Pro Switch-Mode BEC Brushless ESC  V2




Key Features

  • Up to 60-amp continuous current with proper air flow, 75-amp peak
  • 5-volt Switch-Mode BEC circuit capable of 2.5-amp continuous current on any recommended input voltage
  • Drives up to 7 analog or 6 digital standard-sized servos, with the BEC on any recommended input voltage
  • 3–6S Li-Po, 9- to 18-cell Ni-Cd/Ni-MH input voltage
  • Finned heat sinks
  • Programmable motor braking
  • Safe power-arm mode prevents accidental starts
  • Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V), or 70% of battery starting voltage
  • Programmable soft start for helis and airplanes
  • Auto motor shut down if signal is lost or there is interference
  • Programmable timing—5 user-selectable ranges for use with a larger variety of brushless motors
  • Programmable throttle input range (1.1–1.9 ms or 1.2–1.8 ms)
  • Utilizes new smaller MOSFETs technology to minimize weight
  • Radio System Power On/Off Switch
  • Pre-wired connectors—E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads


When performance matters in your high-current applications look no further than the E-flite® 60-Amp Pro Switch Mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated Switch-Mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 60 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic endcaps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range, and more, the E-flite 60-Amp Pro Switch Mode ESC is truly a ‘pro series’ electronic speed control. 


Product Specifications

Brake:Yes - Programmable
Continuous Maximum Current:60A with reasonable cooling
Input Voltage:10.8V - 22.2V
Input Connector Types:13AWG with E-flite EC3 connector
Output Connector Types:13AWG with 3.5mm Female Gold Bullet Connectors
Momentary Peak Current:75A (15 sec)
Length:3.00 in (76mm)
Width:1.30 in (33mm)
Height:0.50 in (13mm)
Weight:2.3 oz (66g)
Wire Gauge:13AWG
Cells w/BEC:3-6S Li-Po or 9-18 Ni-MH/Ni-Cd

Nouveaux produits

Aucun nouveau produit à l'heure actuelle


Copyright © 2011-2012 Oxalium - Design par airpro360